| Area | Exterior |
| Recommended Use | Exterior wood, weathered plastic, concrete, steel, masonry, cladding |
| Base | Water-Based |
| Coverage | Up to 10m² per litre |
| Drying Time | Touch Dry 2-4 hours |
| Re-Coat Time | 16-24 hours |
| Recommended Coats | 1-2 Coats |
| Application Method | Brush |
| Clean Up | Clean brushes and equipment with warm, soapy water and rinse with clean water immediately after use. If spilled, Sadolin Superdec should be removed immediately while still wet, using clean water |
Always ensure the surface to be painted is clean, dry, and dirt free to ensure adhesion.
- Treat any resinous knots with an appropriate blocking primer, do not use a “knotting agent”.
- Degrease any exposed bare timber by wiping with a cloth dampened with methylated spirits.
- Fill any minor defects, imperfections or open joints with Sadolin Woodfiller.
- Do not use Sadolin Superdec on substrates that have had water-repellent preservative treatments applied.
- Base stained and primed joinery – Lightly abrade, in the direction of the grain. Do not break through the surface coating.
It is recommended to perform a test patch on a small area of the surface to be painted to ensure you are happy with the finished results. Do not apply if there is a risk of rain, or when temperatures are below 8°C or above 25°C.
- Stir the product thoroughly and apply using a good-quality brush.
- Do not thin.
- Pay special attention to end grain, tops, and bottoms of the door and under cills for full weather protection.
- Apply two coats of Sadolin Superdec Opaque allowing 16-24 hours between coats.
Note: Always follow manufacturers instructions found on the tin.
Ensure this pack is stored upright and secure at all times, do not store below 5°C or above 40°C.
Reviews
There are no reviews yet.